SMC pneumatic diaphragm pump for what occasions?

The SMC pneumatic diaphragm pump is a new type of conveying machine that uses compressed air as the power source. For various corrosive liquids, liquids with particles, liquids that are highly viscous, volatile, flammable, and highly toxic, they can all be pumped. Do it. SMC pneumatic diaphragm pump has four materials: engineering plastic, aluminum alloy, cast iron, stainless steel. Pneumatic diaphragm pumps are based on different liquid media using NBR, chloroprene rubber, fluoroelastomer, PTFE, polytetraethylene. To meet the needs of different users. Placed in a variety of special occasions, used to pump a variety of conventional pump can not pump the media, have achieved satisfactory results.

SMC pneumatic diaphragm pump for applications:
1, due to the use of gas power, so the flow with the back pressure (outlet resistance) changes and active adjustment, suitable for medium and high viscosity fluids. The operating point of the centrifugal pump is set on the basis of water. If it is used for a fluid with a slightly higher viscosity, it must be equipped with a speed reducer or a frequency converter. The cost is greatly increased, and it is also true for gear pumps.
2, in the flammable and explosive environment with a pneumatic pump is reliable and low cost, such as fuel, fire about the transmission, because: First, after the ground can not produce sparks; second, no heat generated during the work, the machine will not Overheating; Third, the fluid will not overheat due to the agitation of the fluid by the pneumatic diaphragm pump.
3, In the bad central part of the construction site, such as the construction site, the waste water discharge of the industrial and mining, and the impurities in the sewage are complicated and the components are complex, the pipeline is easy to inflict. This causes the electric pump to form an excessively loaded environment and the motor is vulnerable to heat generation. Pneumatic diaphragm pumps can pass through the particles and the flow rate can be adjusted to stop actively when the pipe is blocked.
4, In addition, the pneumatic diaphragm pump is small in size, easy to move, does not require foundation, has a small footprint, and is simple and economical to install. It can be used as a moving material pump.
5, In hazardous and corrosive material processing, the diaphragm pump can completely isolate the material from the outside world.
6, or some experiments to ensure that no impurities contaminate the raw materials.
7, can be used to transport chemically unstable fluids, such as: photosensitive materials, flocculants and so on. This is because the diaphragm pump has a low shear force and a small physical impact on the material.

 Forged Pipe Fittings

   Different from butt weld fittings, some pipe fittings are produced by forging method, they are called forged pipe fittings, including forged O-lets, nipple, union, plug,coupling and so on. According to difference in connection type, there are socket weld pipe fittings and Threaded Pipe Fittings.They belong to high pressure forged pipes, pressure for SW fittings shall be 3000# ,6000# ,9000#. The pressure of forged NPT fittings shall be 2000#,3000#,6000#.

Forged fitting

Forged Elbows, tees,crosses, couplings,half-couplings,plug,bushing are covered by standard ASME B16.11. Their size is not very big. The size for ASME B16.11 forged fittings is 1/8``-4``. 


As for branch outlet fittings, the manufacture standard for weldolet, sockolet, threadolet is MSS SP-97.

Forged Pipe Fittings

Forged Carbon Steel Pipe Fittings,Forged Weldolets,Threaded Pipe Fittings,High Pressure Forged Fittings